XBox 360 Repair Center - Do This Before Shipping Your XBox 360 Away
Ranked #2,307 in How-To, #25,005 overall
XBox 360 Troubleshooting and Repair
Take this tutorial and see if you can stop the XBox 360 3 red light error. For tons of advice, explanations, and to download the tutorial for a clean step-by-step process go now to this XBox 360 Fix site.
Begin the XBox 360 Three Red Light Fix Tutorial Below:
This may seem Obvious, but a simple RESET resolves the problem in over 30% of the cases:
1. Remove any disks and turn OFF the console.
2. Turn the console back ON.
3. While the console is starting, Press and hold the Y Button and then pull the Trigger at the same time.
4. If the 3 red light error is still there, continue to the next step:
Connector Integrity:
1. Turn OFF the console.
2. Unplug all wires connecting to the console, until it's just a bare box.
3. Make sure all the plug-in connectors (sockets) on the box are clean and intact.
4. Plug each wire back into it's respective socket and make sure it's tight.
5. Turn On the console.
6. If the 3 red light error is still there, continue to the next step:
Hard Disk Drive (HDD) and Memory Unit (MU) Integrity:
1. Turn OFF the console.
2. Remove the HDD and MU (if present).
3. Look closely at the connectors and make sure all the pins are clean and intact.
4. All of the connecting pins should be in line with each other.
5. Re-install the HDD and MU.
6. Turn On the console.
7. If the 3 red light error is still there, continue to the next step:
Power Supply:
1. Make sure the console is ON.
2. Observe the color of the LED on the power supply.
3. If the LED is Green or Red, click the Continue button below.
4. If the LED is Orange, make sure the power supply cord is plugged into the console.
5. The LED should return to Green.
6. Turn Off the console, and then turn it On again.
7. If the 3 red light error is still there, continue to the next step:
Overheating:
This is typically the most common cause of the 3 red light error.
1. Turn the console Off.
2. Vacuum all openings on all sides of the console - Do not blow air into them.
3. Relocate the console away from any sources of heat, including sunlight.
4. Stand the console on it's end vertically, on a hard, smooth, level surface.
5. Make sure there are no obstacles blocking any openings to the console.
6. After the console has been turned off for at least 1 hour, turn it back On again.
7. If the 3 red light error is still there, before packing up your XBox 360 and shipping it out for repair, continue to this XBox 360 Red Ring of Death Annihilator
1. Remove any disks and turn OFF the console.
2. Turn the console back ON.
3. While the console is starting, Press and hold the Y Button and then pull the Trigger at the same time.
4. If the 3 red light error is still there, continue to the next step:
Connector Integrity:
1. Turn OFF the console.
2. Unplug all wires connecting to the console, until it's just a bare box.
3. Make sure all the plug-in connectors (sockets) on the box are clean and intact.
4. Plug each wire back into it's respective socket and make sure it's tight.
5. Turn On the console.
6. If the 3 red light error is still there, continue to the next step:
Hard Disk Drive (HDD) and Memory Unit (MU) Integrity:
1. Turn OFF the console.
2. Remove the HDD and MU (if present).
3. Look closely at the connectors and make sure all the pins are clean and intact.
4. All of the connecting pins should be in line with each other.
5. Re-install the HDD and MU.
6. Turn On the console.
7. If the 3 red light error is still there, continue to the next step:
Power Supply:
1. Make sure the console is ON.
2. Observe the color of the LED on the power supply.
3. If the LED is Green or Red, click the Continue button below.
4. If the LED is Orange, make sure the power supply cord is plugged into the console.
5. The LED should return to Green.
6. Turn Off the console, and then turn it On again.
7. If the 3 red light error is still there, continue to the next step:
Overheating:
This is typically the most common cause of the 3 red light error.
1. Turn the console Off.
2. Vacuum all openings on all sides of the console - Do not blow air into them.
3. Relocate the console away from any sources of heat, including sunlight.
4. Stand the console on it's end vertically, on a hard, smooth, level surface.
5. Make sure there are no obstacles blocking any openings to the console.
6. After the console has been turned off for at least 1 hour, turn it back On again.
7. If the 3 red light error is still there, before packing up your XBox 360 and shipping it out for repair, continue to this XBox 360 Red Ring of Death Annihilator
XBox 360 Troubleshooter Demo
XBox 360 System Fix and Repair Blog
Fetching RSS feed... please stand byRecommended Links
- Acai Berry Premium Cleansing Site
- Yet another Acai Berry Cleansing Site
- Colon Cleansing
- 100% Natural Internal Cleasing Formula
- How to Repair 3 Red Lights onXBox 360
- How to repair the 3 red light ring of death without causing permanant damage.
- Governments Grants Owed to You
- Source of Government agencies and private foundations to distribute required funds.
- Payday Loans
- Source of quick cash in an hour until you get your next paycheck.
- Perfect Acai Berry
- 100% Pure Freeze Dried Organic Amazon Acai Berry Capsules
- Stop Ringing Ear
- 11 ways to stop Tinnitis, or ringing in the ears.
Explore related pages
Fixing Xbox 360
- After receiving your Xbox 360, perhaps as a Christmas gift by your mom, or buyin...
Ring Of Death Xbox 360 Fault - All Faults Finally Solved- Finally a complete and simple solution to the Ring Of Death. The most annoying X...
Xbox 360 Repair Guide – Xbox 360 Repair Video
- I chanced upon an Xbox 360 repair guide recently that claims that you can repair...
Xbox 360 Repair Guide - 3 Red Lights Fix- Xbox 360 Repair Guide - 3 Red Lights Fix... Are you suffering from the 3 red ri...
Microsoft Xbox 360 Repair Guide - Xbox 360 Fix, Troubleshooting, Xbox 360 Repair Kit- Need Xbox 360 repair? Does your Xbox has a red lights that kept you from enjoyin...
