How to re-upholster furniture

This couch belonged to my grandmother; it is from the 50s and has been recovered at least twice; with this being the third time. The blue fabric that is being partially removed is a blue corduroy. It is a very pretty fabric but sticks to pet fur like a magnet. I don't know how my grandmother kept it clean with her cat; she much have vacuumed it daily.

While this is listed as just one step this is a huge process and, in my opinion, the hardest step in recovering a couch. Your hands are going to hate you as you pry out old staples one by one. SAVE OLD FABRIC FOR USE AS TEMPLATE IN LATER STEPS.

Often the flat head screwdriver isn't enough and you have to pry out the staples with pliers. You'll probably also need to remove screws, bolts, and possibly even giant staples. So, try to figure out what tools you will need before starting so you don't have to run to the store when you are already covered in whatever stuff fell inside your couch over the years.

If the foam and batting is still clean, doesn't smell, and is not broken down you can save it. This couch has always been in a smoke free house, spills were always cleaned up quickly, and still had a surprisingly good shape to it. So, I was able to save the foam. There was one butt indent area from too many hours playing video games. This was corrected by laying down a new layer of thick batting. Next time this couch is recovered it will need new foam and batting as keeping it was a borderline decision (but I don't want to waste something that still has life in it). In the above photo the foam/batting is shown flipped upside down next to the couch frame. This was the easiest way to keep the foam together while I worked on the rest of the couch.

The support bands (there may be a more technical word for these) were in pretty good shape aside from being stretched in some places. So, I decided to just pry them off one side, stretch them out again (done by hand) and use a staple gun to re-attach. This decision was made for two reasons. Main reason, someone had bought out all the support materials from my local supply stores and I needed to get the project done faster than they would be restocked. Secondary reason, it was hard enough to pry up one side of the bands, I didn't want to have to pry up both sides unless I had to. I think I'd suggest replacing them if you are willing and able; but so far so good the re-stretched old bands are holding up just fine.

Just lay the batting over the couch. Starting from the center of the long sides staple out to the ends. Batting is forgiving and will stretch to fit. No need to go overboard on staples since the fabric will also be stapled over it.

I just threw the fabric over the base and started stapling making sure to keep the fabric pulled hand tight at all times. Keep a flat head screwdriver and pliars handy in case you need to remove a staple to adjust the fabric. Start by spacing your staples every 6 inches then go back and fill in every two inches (or more) after the fabric is positioned where it needs to be.

To make my life easier and because of the type of fabric I was using, I opted for a contemporary look. By that I mean that I folded the sides and stapled them down instead of trying to cut out a dart to fit the corner then sew it back together. It took a few tries to determine how I wanted to fold it but the end result turned out nicely. However, I do not suggest the folding technique for all couches nor does it fit all styles of decor. In most cases you are going to have to break out a needle and thread.

The wrinkles above is what happens when you sit on a couch that is covered in this manner and doesn't have any buttons keeping the fabric in place. So, you may opt to secure the fabric with upholstery buttons if you have a long span of area that is covered. With this couch we know from experience that the buttons created a place for dirt to become trapped, so we opted to not add them back. The wrinkles are easily smoothed out by hand. But we could only get away with this because this is a very sturdy fabric (it could probably be used on outdoor projects).

For the exposed back of the sofa, I folded a piece of fabric over and pinned it into position. After it was pinned exactly where it needed to be I used decorative nails (found at any home decor or fabric store) to secure it in place.

Use a tape measure to make sure spacing is accurate. Rubber mallets must be used with decorative nails as regular hammers will damage their appearance.

As you can see, I opted to keep the old blue fabric on the pillows and across the front trim. I have two blue chairs (not visible in view) and this helped to tie the couch into the overall room. I originally planned on replacing all the old fabric but liked this look and decided to stay as is for at least a while. As I am able to further blend the gray in with the rest of the room decor I may opt to further change the couch design. If I do replace the pillows it will be with one large pillow instead of the 3 smaller pillows. If I make that change I will post new pictures.