How to Build a Pole Barn - DIY Pole Barn Plans

The first step after you general site selection is to excavate and prepare the ground for your building.

You will want to level the area to build on, which can quickly be done with a rented bobcat or other similar piece of equipment. After leveling, you will want to dig out your dimensional base for the pole barn.

Use about 4 inches of gravel to fill in the entire area to be built on, and make sure this layer of material is level and even after pouring.

Be sure your pole barn blueprints are clear as to the exact amount of space that needs to be cleared. The actual area will be slightly larger than the actual building size, so consult your barn blueprints before you finish this important step.

You can now get to work on framing around the base to install the floor panels and joists.

The second major step in this project is to frame up the walls.

You can use snap chalk to mark on the floor where the wall plates should go, and use the recently installed floor space to cut and assembly each section of wall.

Be careful not to build too large a section of wall frame at one time, as lifting into position can become a challenge.

MasterShedPlans.info contains detailed, step by step instructions on how you can quickly assembly the pieces of your walls and have them up and in place with minimal effort.

Always remember to practice safety first when doing this project, nothing can ruin your day more than a trip to the emergency room.

Perhaps the most difficult section to do is the framing of the roof.

Getting the angles needed to accurately get the roof framing installed can be difficult. Having good tools here can really pay off well. Most smart roofers will pre measure and pre cut all lumber for this portion of the project, using the dimensions found in your pole barn blueprints.

Using prints to pre cut will save a ton of time and headache. Be sure you also use metal plates and brackets to reinforce joints and other areas of weakness in the structure.

You can break up the roof frame into 8 sections, 4 on each side, for easier lifting and installation. Just make sure enough brackets are available to support the various joints and jousts that will be needed.

Finally, after completing the roof areas, you can go ahead and install the roofing material if your choice to finish off this part of the pole barn project.

At this point in your project, you can smell the finish line. Now you can install the side boards and materials of your choice that will finish off your new pole barn.

When choosing a material to use, be sure you investigate various siding options. Plastics and synthetics are least expensive, but will require replacement over time. Using natural pressure treated lumber is more expensive, requires some preventative maintenance, but will give you a much sturdier pole barn.

Also, a key point here is to make sure you cut out and install the framing for the door and any windows you may want in the side. Your side walls should be clearly marked by now, and you can easily measure out window and door space to include in your cutting of the side materials.

To get a complete list of options, and more step by step instructions and diagrams on how to build a pole bar, you can visit MasterShedPlans.info.