Nubra strapless adhesive bra

How to apply instructions for all Nubra strapless bra styles.

1. CLEAN YOUR SKIN before use: This is the most important step. Gently clean your chest area with mild soap and water to remove body oil and residue from skin. If your skin is particularly oily, then use alcohol on a cotton pad to remove excess skin oils. Dry your skin with a soft towel.

2. PLACE ONE SIDE ON AT A TIME with center clasp attached: Stand in front of a mirror. Flip one cup outward while holding the bra cup by the edges with both hands. Position the cup to your desired breast angle and gently smooth the cup edges firmly to the breast with your fingertips. Repeat the same application on your other breast, being sure both sides are equal in height. When both sides are attached, press your palms to the cups and gently roll while pressing cups to skin to warm the adhesive so they stick on well.


More SUGGESTIONS:
For a fuller look, wear the NuBra at a higher position than your breasts. The bra cups are designed to be thinner on the lower portion of the cups so they can blend with your breasts without showing their edges. It is normal if NuBra® does not cover your entire breasts. To create cleavage, place the stick on bra cups farther away from each other so when the front closure is secured, this will tighten the cups to create that ultimate cleavage you're looking for. Note: If you are not satisfied with the results and must reposition the bra, peel off the bra gently and reapply. Too many attempts will reduce the effectiveness of the adhesive. If this happens, simply wash the bra cups and let air dry before reapplying.

DO NOT USE moisturizers, perfumes, powders or other skin care products prior to use, as this will reduce the effect of the adhesive.

HOW TO REMOVE NUBRA:
Take your time, detach the front closure first, then gently peel off the bra starting from the top and gradually downward. If any adhesive residue remains on the skin after removal, simply wipe skin with a soft tissue to remove.

CLEANING Nubra IS ESSENTIAL AFTER EACH WEAR

These instructions apply to all styles of Nubra Strapless bras.

Always wash your Nubra after each wear to remove any body oil or dead skin which clogs the pores of the patented self healing adhesive.

You can easily clean all Nubra styles bra cups by using a gentle soap and warm water. The best soap to keep the adhesive sticky in my experience is good old clear amber glycerin soap (no moisturizing soaps!), rinse till all the soap is gone. The bra cups will not feel sticky while there is soap on them. Then air dry! Once dry, the adhesive will amazingly regenerate! Nubra stick on is guaranteed to stay securely in place even when you sweat (when instructions are followed carefully).

It is important that you follow all the instructions carefully prior to wearing NuBra. DO NOT USE moisturizers, perfumes, powders or other skin care products prior to use, as this will reduce the effect of the adhesive.

1. While holding one bra cup in the palm of your hand, wet the adhesive surface with warm water and add a small amount of mild soap.Gently use the palm of your other hand to create a circular motion to clean. DO NOT USE your fingernails, as this can cause a tear in the adhesive.


2. Rinse the bra cup with warm water to remove all soap residue. Shake off all excess water and place into the original tray to AIR DRY.

3. DO NOT USE A TOWEL TO DRY the adhesive side. When your Nu Bra cups are completely dried put them back in the original tray and cover with the lid. This will prevent dust and lint from gathering on the adhesive. The better you care for your Nubra cups, the longer they will last.

CAUTION
DO NOT USE A TOWEL, or place the adhesive side against clothing, as the lint will gradually clog the adhesive. If something does get onto the adhesive, carefully pick them up with your fingers. Try to avoid the clothing that sheds fibers easily.

DO NOT USE A BRUSH OR FINGERNAILS, or any sharp objects to clean the surface. This will cause permanent damage to the adhesive.

DO NOT CLEAN WITH ALCOHOL, Bleach or any cleaning solutions. All you need is warm water and non moisturizing soap.

KEEP SHARP OBJECTS AWAY, from your NuBra. If you puncture your NuBra by accident, use an adhesive-like bandage to prevent further split.

NuBra® Beach silicone push-up gel breast Enhancers are made of the highest quality silicone. With baked on adhesive and their unique triangle shape, they are ideal for use with swim suits, bikinis or any of your casual or unique styled clothing iside conventional bras. These silicone gel enhancers will not fall out of your conventional bras or swimwear!

There is no center clasp so if you have a tight fitting top, they can be worn under the most plunging neckline inside a conventional bra!


Nubra gel enhancers use the same skin-friendly sticky adhesive used with the original NuBra self adhesive bras and are reusable, easy and comfortable to use! They fit into bikinis, swim suits or even conventional strapless or regular bras!

Check them out at http://www.nubrabeach.com