Parts for Water4Gas System

Ball Jarden 37000 Ball Wide Mouth Plastic Lid
Sheet of Plexiglas 1/8" or 1/4" for Tower (Electrode Core)
316L Stainless Steel 20 gage wire
1/4" x 7/8" or 1" Bolt ( 2 per Jar)
1/4" Flat washer ( 2 per Jar)
1/4" Split washer (2 per Jar)
1/4" Nut ( 2 per Jar)
1/4" Wing Nut Coarse ( Black and Red)
1/4" Barbed Elbow ( 2 per Jar) buy here!
1/4" Barbed Connector buy here!
Adjustable Bubbler DAB or DSHB 1/4" buy here!
High Flow Check Valves find here! or Check Valve (Small) find here!
1/4" 0.170 ID. Clear Vinyl Tubing
1/4" 7/32 ID. Vacuum Hose
Universal Vacuum Tee
8 Amp in-line Fuse Holder
16-14 AWG Butt Terminal
16-14 AWG Spade Terminal 1/4"
16-14 AWG Quick Splice

Remember you get no help with install without a purchase number!

Fuel-Injected vehicles with OBD I and OBD II "On Board Diagnostic" computer; the oxygen sensors must be intervened with by one of the following methods or you will not achieve an increase in your MPG!

When installing an HHO Electrolyzer on fuel-injected vehicles with OBD I and OBD II (On Board Diagnostic) computer, the Oxygen Sensors must be dealt with for the following reason.

The HHO or H2O Water4Gas generators will supply more oxygen to your engine, consequently the vehicle computer will sense more oxygen, it then considers the fuel mixture too lean, and will compensate by supplying more fuel, which is NOT needed; a waste of gas, poor fuel economy, and increased pollution!

How the MAP value is used

The manifold absolute pressure measurement is used to meter fuel. The amount of fuel required is directly related to the mass of air entering the engine. The mass of air is proportional to the air density, which is proportional to the absolute pressure and inversely proportional to the absolute temperature. Engine speed determines the frequency, or rate, at which air mass is leaving the intake manifold and entering the cylinders. As found on Wikipedia.