Sharkbite Instant Push-Fit Connection System

1. Cut the tube so that the ends are square.

2. Ensure that there are no burrs or damage to the cut end.

3. Wherever possible, proper tube cutting tools, such as rotary tube cutters (copper tubing) or tube shears (for plastic tubing), should be used.

4. Once the tubing end is cut square and clean, use the SharkBite® Depth Gauge (sold separately) and a scribe to mark the insert depth on the outside of the tubing.

5. This mark is used to ensure that the joint is assembled correctly.

6. To assemble correctly, the tubing needs to be pushed into the fitting until it meets the tube stop.

7. Follow the following three steps to insert the tubing into the fitting.
a. Insert the tube through the release collar to rest against the grab ring.
b. Push the tube firmly with a slight twisting action until it reaches the tube stop.
c. To ensure that the tube is correctly inserted, check that the depth mark is within 0.05 in (1.3 mm) of the end of the release collar.

No tools are required for connecting the fittings. However, the SharkBite Safe Seal Tool is recommended for de-burring and measuring the depth of the tubing. The tubing must be cut square, free of burrs and debris before installing. When disconnecting the SharkBite push-fit fitting the disconnecting clip or disconnecting tongs are required.

Disconnection of the joint can only occur by using either the SharkBite® disassembly clip
or the SharkBite® disconnecting fork tool. By applying pressure to the release collar with
the clip or the fork tool, the grab ring teeth are splayed. This action releases the tube, allowing it to be removed from the fitting.

1. Place the SharkBite® disassembly clip around the tube with the non-branded face against the release collar. If using the SharkBite fork tool, place the forks around the fitting assembly. The fork end with the SharkBite brand logo should be positioned around the tube and the other end around the neck of the fitting.

2. Push the clip against the release collar and pull the tube with a twisting action to
release the tube. If using the SharkBite® fork tool, squeeze the tool with one hand and pull the tube with a twisting action to release the tube.

3. Check the fitting and tube end for damage. The fitting should be free of damage and foreign objects. The tubing should be free of damage and marks on the outside diameter. If the tubing is damaged or marked, then cut and use a new section of tubing.